DIY Hack for Installation of a Garage Door in Ottawa

People living in Ottawa are aware of the importance of a garage door. Not the regular one, this door apart from shielding your car also adds an aesthetic appeal to your apartment. A well-functional garage door makes life easier and manageable too.

To your surprise, 70% of the homeowners in Ottawa use garage doors as the main entrance to their abodes. So, it is imperative to take care of this door to deter the permeability of intruders. If the garage door is already in its adulthood, i.e. 20 years, it high time you opt for garage door installation Ottawa and get a new one.

New doors are always safer, and easy-to-use. So, here’s a simple DIY guideline if you feel the need to replace the door at the earliest.

garage door installation

Step 1: Start by releasing the tension

The initial step entails the release of tension in the torsion before you embark on garage door installation Ottawa. Then clamp the locking pliers on the shaft of your torsion spring. Make sure you wedge the pliers against garage door’s header wall.

Step 2: Dismantle the Existing Opener and Door

Once the tension is released, you should disconnect the door-opener starting from the panels of the door. Unscrew all the hinges, tracks, and other parts of the doorframe.

Step 3: Next Install the Door Panels

This is a little tricky one. Before initiating with the installation, first assess whether you want need a 2-car garage door or a single one. In accordance to your need, consider the axle support and watch out the hinges to complete the process. You may take the aid of a professional technician with years of proven expertise in garage door installation Ottawa.

garage doors ottawa

Step 4: Tighten the Hinges

Now you have to tighten the hinges for installing the tracks. For proper installation, make sure to attach the brackets to those vertical track pieces. Once you are done with attaching the brackets, check the alignment from top to bottom.

Step 5: Attach the assembled spring to the track

In this step, you need to assemble all the pieces for supporting the springs. You may consider going through the instruction guide for a better overview.

Step 6: Bolt them at once

Next, connect the horizontally-aligned track to the existing vertical one on the garage door. Drill a hole via the horizontal track, and later bolt them together.

ottawa garage doors

Step 7: Put in the spring

This is another easy step where you simply need to spot the opening’s center and pin it on the header. Make sure that you connect those spring anchors tightly as these prevent popping up from high tension.

Step 8: Now install torsion rod & pulleys

Make sure the torsion rod is driven into the holes directly without much interruption. Additionally, in this step, you also need to attach those pulleys to the end of the rods respectively.

Step 9: Tie the cable

The penultimate step involves the attachment of the cable to the pulley wheels both ways. Tightening a pair of locking pliers will prevent the rod from turning in multi-directions while you at work.

Step 10: Secure the springs

Lastly, once you reach the adequate tension, fasten the bolts of the anchor for successful garage door installation Ottawa. After locking them, don’t forget to take out the pliers from your torsion rod.

However, if you are dubious of your self-sufficiency, hire a professional service for all your garage needs at a reasonable price.